I diy myself a microvewave/aluminium foil dispenser today😎

Though it looks harsh on craftmanship but it does make pulling and cutting process much precise and easier.Beside some screw and pipe holder all material cost is free because it is left over construction pvc pipe and pallet wood i pick up at aside of street tools required just angle grinder and drill.

Top | New | Old

Matt85 · 36-40, M

Looks sturdy!

UsernameAlreadyInUse · 26-30, M

@Matt85 yes also the roller more stable and smooth when you pull compare to those dispenser make of plastic.

Matt85 · 36-40, M

@UsernameAlreadyInUse Yeah, they are a bit fiddly.

Barefooter25 · 46-50, M

Crafty and ingenious handiwork. When the middle of December comes around, you can use your aluminum foil dispenser to celebrate Festivus.

SW-User

A little trimming, little sanding, little paint... could be awesome. Very functional 👍🏻

UsernameAlreadyInUse · 26-30, M

@SW-User yeah,actually going to sanding the sharp edge tomorrow because running out of grinding disc today.😊

SW-User

@UsernameAlreadyInUse hope you'll post the finished product. Looking forward to it.

wildbill83 · 41-45, M

no bearings on the rollers? 🤔😉

UsernameAlreadyInUse · 26-30, M

@wildbill83 no need,i use 1/2 inch pvc pipe as the rolling shaft diameter is smaller than plastic wrap cardboard tube it will move freely.

MarkPaul · 26-30, M

Impressive. Nice craftsmanship.

Add a comment...