Been working on a window install bird feeder. Thoughts on the design so far?

Going to be using a transparent material for the viewing port, might apply a one way viewing film over it. Also got to adjust the bottom a bit to make it attach onto my window frame better.

This page is a permanent link to the reply below and its nested replies. See all post replies »

Matt85 · 36-40, M

if you buy one it's likely to run into less problems

Teirdalin · 31-35

@Matt85 Checking on amazon, seems that's about $60 standard, and is a very chinese plastic product as well. I got about 9400g of filaments of various styles and 1000g of transparent filament to print with; so I may as well just make my own. 🤷🏼‍♂️

Matt85 · 36-40, M

@Teirdalin Go for it!!