I Love Power Tools And This Group Is For Both Sexes

@Livingwell How are those Grizzly lath/mill combos? I've though if getting one and replacing the stock gears but I hear mixed opinions about them.

@MethDozer Mine has worked perfectly. The gears are heavy metal and I haven’t had a problem. I did replace Or modify a few parts that were sloppy like the fine control for the spindle depth. I did buy a small lathe that has plastic gears. I’ll likely replace those. I’m getting within .001 inch accuracy so not bad. The quality of bits really matter.

@Livingwell Oh I've got chests full of tooling.

Sounds good enough for me. The dialing them in part is what I was asking. I know from sources they are like all the other China doll mills they need a little fine tuning at home but that's fine.

@MethDozer You are correct. The table keys needed so fine tuning to make the table solid. I’m a novice so you can do a much better job than I. I definitely recommend a DRO. I bough an inexpensive set and hard wired the power.

@Livingwell You best get that whale knife. Going fast. ;)