This page is a permanent link to the reply below and its nested replies. See all post replies »
SteelHands · 61-69, M
Yes. Lesson 1. If you don't know what you are doing take it to someone who does.
Lesson 2. Spare no expense when it comes to components and anything even slightly bent or damaged gets replaced.
Lesson 3. Double check every step, don't forget to clean every single part, use approved materials a n d torque every bolt to factory spec.
That takes the right tools.
Factory bulletins.
And funds.
Lesson 2. Spare no expense when it comes to components and anything even slightly bent or damaged gets replaced.
Lesson 3. Double check every step, don't forget to clean every single part, use approved materials a n d torque every bolt to factory spec.
That takes the right tools.
Factory bulletins.
And funds.