Today I had to fix someone else's mistakes at work. All they had to do was make sure their measurements were right. I pull the 220 inch iron beams off of the cart and cut them and drill them once they mark where to drill. Then I categorize them by work order and seperate them onto carts to later weld onto outgoing shipments. The guy marked the wrong lines for almost half of them and mislabeled the paperwork so I had to go back and redrill new holes and relabel each piece for a set and then reorganize them. As you can see by the length, they're not really that small and light lol. The math has my head hurting just as much as my back and arms today.
